User Tools

Site Tools


suphybrid1:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
suphybrid1:start [2019/07/26 11:49]
support
suphybrid1:start [2020/06/12 11:32] (current)
support
Line 1: Line 1:
 ===== Hybrid 1 ===== ===== Hybrid 1 =====
- +{{:hybrid-1_2015161x57_2x.jpg?200|}}
-**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?\\ +
-**__Answer:​__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.\\ +
-Set the Send and Receive in the middle and the LC and HC to OFF.\\ +
-When called in adjust the potentiometer until the lowest input signal is heared.\\+
 \\ \\
-The C balance should be set to the situation that the Hybrid ​has the lowest influence on the bus that you listen ​to on the mixer.\\ +^**__Question:​__** How do I connect a Hybrid ​to my mixer?^ 
-So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn'​t change.\\ +|**__Answer:​__** Follow ​the instructions in this .pdf document: [[https://​www.d-r.nl/​wiki/​dokudata/​faq/​hybrid2/​How to connect Hybrid1.pdf|How to connect a Hybrid1]]|
-When this is okay you can fine adjust the R balance.\\+
 \\ \\
-The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\+^**__Question:​__** Could you give us an explanation about the dip switch of C-BALANCE?​^ 
 +|**__Answer:​__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.| 
 +|Set the Send and Receive in the middle and the LC and HC to OFF.| 
 +|When called in adjust the potentiometer until the lowest input signal is heared.| 
 +|  | 
 +|The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| 
 +|So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn'​t change.| 
 +|When this is okay you can fine adjust the R balance.| 
 +|  | 
 +|The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.|
 \\ \\
 +[[start:​|{{:​iconhome.png?​100|Home}}]]
suphybrid1/start.1564134594.txt.gz · Last modified: 2019/07/26 11:49 by support