User Tools

Site Tools


axumstudioremote:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
axumstudioremote:start [2019/04/30 10:06]
support
axumstudioremote:start [2019/07/22 09:08] (current)
support
Line 1: Line 1:
 **__Question:​__** How can I configure my Studio Remotes in the Axum? \\ **__Question:​__** How can I configure my Studio Remotes in the Axum? \\
 **__Answer:​__** Link: [[axumstudioremote:​start|follow the instructions on this page.]] \\ **__Answer:​__** Link: [[axumstudioremote:​start|follow the instructions on this page.]] \\
 +\\
 To connect a Studio remote to your Axum you'll have to change the Jumpers on the MicAD card to GPIO instead of GPO settings.\\ To connect a Studio remote to your Axum you'll have to change the Jumpers on the MicAD card to GPIO instead of GPO settings.\\
 +\\
 {{ :​axumstudioremote:​micad.jpg?​direct |}} {{ :​axumstudioremote:​micad.jpg?​direct |}}
 +\\
 Set the Jumpers to the 1-2 and 4-5 Jumper positions.\\ Set the Jumpers to the 1-2 and 4-5 Jumper positions.\\
 +\\
 Then you can configure the functions of this GPIO'​s.\\ Then you can configure the functions of this GPIO'​s.\\
 +\\
 {{ :​axumstudioremote:​console1-4_rack_config-mic1b.png?​direct |}} {{ :​axumstudioremote:​console1-4_rack_config-mic1b.png?​direct |}}
 +\\
 In this example the Studio remote will show when the user presses the Cough and Comm button.\\ In this example the Studio remote will show when the user presses the Cough and Comm button.\\
 An other option can be to show the Redlight connected to the Microphone input.\\ An other option can be to show the Redlight connected to the Microphone input.\\
 +\\
 Setting 1027 - 1034 are the GPI settings and react to the buttons of the Studio Remote.\\ Setting 1027 - 1034 are the GPI settings and react to the buttons of the Studio Remote.\\
 Setting 1051 - 1058 are the GPO settings and will make the LED's of the Studio Remote go ON.\\ Setting 1051 - 1058 are the GPO settings and will make the LED's of the Studio Remote go ON.\\
- +\\ 
-[[SupAxum:start|Go back to the Axum Wiki]]+[[https://​www.d-r.nl/​support-request.html|Support Request]]\\ 
 +\\ 
 +Go back to the [[SupAxum:​start|Axum]] ​support page.\\ 
 +\\
axumstudioremote/start.1556611605.txt.gz · Last modified: 2019/04/30 10:06 by support